EJMP - Expanded Jet-Mix Auger System is designed for making jet mix column below the ground level.
The expadable auger in its retracted mode maintains a small diameter of Ø500mm
minimise the disturbance to the ground condition. At the intended
depth underground, the auger is expanded by water pressure actuation,
increasing the auger diameter from Ø500mm to Ø1500mm.
Patented telescopic extendable
drilling rod designed with special joint with heavy duty seal packing
to withstand pressure for foundation and ground engineering work like:
.Deep bored piling
.Soil Mixing pile (SMX)
.Medium pressure soil improvement pile
.Spun Pile – Pre-boring to soften and liquefy the hard strata before
sinking the spun pile
.Micropile
Benefits of the User
1.
Deeper drilling depth - Telescopic feature extends the
drilling depth of the machine.
2.
Withstand high pressure - Special joint with sealed packing
can withstand air and grout pressure for DTH and sand/cement grouting
job.
3.
Site personnel safety – Simple locking system without lock
pin allows the rig operator to lock and unlock the extended rod without
the help of another site personnel going near to the rig. Thus
eliminating the risk of falling into the bored hole or injuries cause
by falling object from the drilling rig.
APPLICATION
OF EXTENDABLE DRILL ROD TO ACHIEVE DEEPER SOIL MIX COLUMN
Soil consolidation by grouting
requires special drilling rods coupled with nozzles and high pressure
(200~400 bars) pumps. Consistency in mix and achieving designed
diameter is always a challenge to the contractors.
Our Soil Mixing Expandable Augers are designed to achieve the above
criteria at a much lower cost and higher efficiency. Using expandable
arms with nozzles allow cutting and mixing of soil with lower operating
pressure of only 30~40 bars. Consistency in mix and diameters are
enhanced due to the arms which mixes as well as cut. Surrounding soil
are also less disturbed due to smaller diameter hole made in the
penetration phase. In the mixing phase, the column can be formed as a
continuous column or partial column can be achieved during from the
designed depth upwards.
As the blades of the expandable arms are made of special material for
cutting, it is suitable for construction of contiguous columns.
For enlargement of drilling diameter
at any drilling depth. Suitable for :-
1.
Anchors
2.
Grouting
3.
Micro piles
4.
Cement Columns.
The requirement for opening the
blades are min. Pump pressure of 30 bar and flow rate of 100 litre. The
blades will retract by itself under tension of spring when no pressure
is applied.
.NO.21, DING HU 1ST,
TA HWA VILL, KWEI-SHAN HSIANG, TAOYUAN HSIEN, TAIWAN, R.O.C.
.TEL:886-3-328-7883 , 328-8363 .FAX:328-8732 .Email :
chlee783@ms48.hinet.net